PENTENS T-206 Water-based Acrylic Paint

────── Taiwan Green Material Label Product  ​​

PENTENS T-206 is a specially produced by new type of acrylic resin compound for use on both internal and external wall.

ADVANTAGES

  • Wear-resistance
  • Can resist to ponding water
  • Easy to use
  • Water based, environment-friendly
  • Low VOC

USES

  • Internal and external wall
  • Ceiling

PHYSICAL DATA

APPLICATION

Surface Preparation
Surface must be sound, dry and clean (free of dirt, gravel, pollution, mildew and all foreign material). Apply if any rain is imminent. Repair flashings and damaged areas. Cracks and old bitumen joints shall be repaired first. 

Application
Substrate should be primed with a 1:3 mixture of PENTENS T-007 and water or PENTENS T-206 with 20~30% of clean water and then plaster directly to the surface . Brush on at the approximate rate of 0.3 kg/m².
On areas exposed hot drying winds. 2 to 3 thin coats of paint may be more successful than 1 thick coat.
PENTENS T-206 is suggested to apply at least 2 coats. Brush on at the approximate rate of 0.2 kg/m². The first coat should be applied in one direction only. If possible the second coat should be applied at right angles to the first.

Leave to cure for approximately 2~4 hours before applying second coat. PENTENS T-206 can be installed with conventional airless spray equipment, brush or roller.

Notes
Minimum ambient and substrate temperature is 5°C. 

Never apply more than 0.2 kg/m² of PENTENS T-206 in one single layer.
Apply only to clean, sound substrates where surfaces should be well dampened but free of surface water and leaks.
Thoroughly agitate contents before use.

SAFETY

Impervious gloves and barrier cream should be used when handling these products.
Eye protection should be worn. In case of contact with eyes, wash thoroughly with plenty of water and seek medical advice if symptoms persist.
If contact with skin occurs, it must be removed before curing takes place.
Wash off with an industrial skin clearer followed by plenty of soap and water. Do not use solvent.
Ensure adequate ventilation when using these products.