PENTENS E-10 Water-dispersed Two-component Epoxy Resin

────── Taiwan Green Material Label Product  

PENTENS E-10 A reactive two-component water based epoxy system with extremely low V.O.C. (volatile organic carbon). E-10 is safe to use in sensitive locations is environmentally friendly.

ADVANTAGES

  • Environmentally friendly
  • Applied to damp surfaces
  • Applied to freshly laid gardened (green) concrete
  • Negligible odor and toxicity
  • Excellent adhesion to most substrates including brick, masonry, concrete, compressed fiberboard, stone and timber

USES

  • As a primer of water-based waterproofing/ flooring works
  • As a binder/sealer for fiber glass mat in tank lining works
  • New and old concrete bonding agent
  • Multi-purpose adhesive

PHYSICAL DATA

APPLICATION

Surface Preparation
All surfaces to be treated must be structurally sound and all previous coatings, adhesives, efflorescence or laitance should be removed by chipping, abrasive blast cleaning, high pressure water washing, mechanical scrubbing or other suitable means.
Very dry and highly porous surfaces should be sprayed with a fine mist of water prior to application of the E-10.
Mixing
Each component should be individually mixed to form homogeneous components prior to mixing.
Only mix as much as may be used within the pot life of the product and avoid excessive aeration during mixing.
Application
Spread the material using a roller, brush or spray method to at the approximate rate of 0.2 kg/m² achieve a smooth coverage and finish. Wait 24 hours to cure then apply topping. 

Spread the material using a roller, brush or spray method to at the approximate rate of 0.2kg/m² achieve a smooth coverage and finish. Wait 24 hours to cure then apply topping. 

SAFETY

Impervious gloves and barrier cream should be used when handling these products.
Eye protection should be worn. In case of contact with eyes, wash thoroughly with plenty of water and seek medical advice if symptoms persist.
If contact with skin occurs, it must be removed before curing takes place.
Wash off with an industrial skin clearer followed by plenty of soap and water. Do not use solvent. 
Ensure adequate ventilation when using these products.